In this post, I show you how I prepare the 👍 best and safest ABS juice/slurry solution for ABS 3D Printing on glass heated bed.
Basically, it is a mixture of wood glue and water which I apply a very thin layer onto the heat bed glass plate. This has helped me great deal with ABS 3D printing without part lifting up from the glass plate. ❤️
This cheapest solution of “ABS juice” mixture which can last you years to come is safe to use when heated compared to any other solution that you found on YouTube videos such as hair spay, acetone and ABS craps (ABS slurry) mixture. Hair spay will make your head spin and nausea because when heated it releases toxic fume, ABS slurry with acetone has terrible smell if you want to convert your apartment into nail spa. Also, imagine how to clean that stuff off. Besides, if you dump acetone into your drain you can kiss your ABS plumbing good bye with big repair bill. I advice not to use ABS slurry with acetone. Neither do I advice using hair spay.
If you value your health , please use this safe wood glue mixture with water solution to make your own DIY ABS juice for your ABS 3D printing needs. Cleaning is with soap and water to remove that thin layer of wood glue on the glass plate. I have only been 3D printing with ABS for the past 6 years and I know 100% that this is the best and cheapest solution for ABS 3D printing. ABS printing using 3D printer is not that hard, you just need a good heat bed temperature of 110°C and you’re golden.